Audi 80 ACE invent jetronic Installation

punktwone · Post by **punktwone** » 11 Dec 2020 15:13

Hi guys.
I have to write in englisch, because i'm from germany and can't speak russian.
Just wanted to install the invent jetronic kit, but theres no manual for Installation specific at a audi 80 ACE.
For now, i need a guide for adjusting the ignition Distributor. It is different to that one from the NG and Also from the one in Audi 100 ACE
Could someone explain to me, how i could find the correct window and on which side i have to cut the 1,1mm?

Tanks for your help

Post by **jhm** » 14 Dec 2020 14:24

Hi, check this short guide

Post by **jhm** » 14 Dec 2020 14:26

Mark case next to 1-st cylinder spark cable

Post by **jhm** » 14 Dec 2020 14:29

Remove distributor cap and turn crankshaft to align rotor with your mark

Post by **jhm** » 14 Dec 2020 14:30

Remove distributor. Keep rotor aligned to mark

Post by **jhm** » 14 Dec 2020 14:32

Mark distributor vane, which is at the center of the hall sensor. This vane should be cut by 1.1mm

OldSamuray · Post by **OldSamuray** » 14 Dec 2020 20:26

Do not forget, on the ACE motor the rotor rotates counterclockwise

punktwone · Post by **punktwone** » 19 Dec 2020 16:40

I think it works.
How could i check, if its functioning?

Post by **jhm** » 29 Dec 2020 15:12

punktwone wrote:I think it works.
How could i check, if its functioning?

Phase will lit green in Commander